Vanner RE Series Manuel d'installation télécharger pdf (Page 14)

Component Identification and Description of Operation



2001 Phone: (614) 771-2718 RE-ACM

Vanner Inc. FAX: 614-771-4904 Owners/Installation Manual

4282 Reynolds Dr. www.vanner.com Rev 0.1a

Hilliard Ohio 43026 RE-ACM-Owners_Man_R01a.doc

INCORPORATED

INCORPORATEDINCORPORATED

INCORPORATED

(3) Knockout Entry/Exit for AC Wiring and Raceway

This knockout provides for the routing and termination of AC Wiring from the Grid and to the AC load to

be powered from the RE-4500 Inverter/Charger.

This knockout also matches up with the AC knockout on Vanner accessories such as the RE-4500 and

the DC Control Panel. This knockout is a standard size 1.701” to accommodate 1 ¼ “ conduit.

(4) DC Raceway

This raceway provides a method of routing DC cables through the ACM to connect to the RE-24-

4500DGT Inverter/Charger or the RE24-DCM DC Control Module.

F 4 Figure 4.0-3 DC Raceway Terminations

RIGHT

BACK

FRONT

LEFT

DC RACEWAY

GENERATOR

CONTROL

START

GND

RUN

+24V

Generator Control

Connector

Generator Control

Terminals

(5) AC Raceway

This raceway provides a method of routing AC cables through the ACM to connect to the RE-ACM to the

RE-24-4500DGT Inverter/Charger, to the utility, to the generator, and to the AC loads.

The Figure below shows the terminations in the ACM for AC connections.

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 23 24

Pas de commentaire

Vanner RE Series Manuel d'installation Page 14