Vanner RE Series Manuel d'installation télécharger pdf (Page 9)

Important Safety Precautions



2001 Phone: (614) 771-2718 RE-ACM

Vanner Inc. FAX: 614-771-4904 Owners/Installation Manual

4282 Reynolds Dr. www.vanner.com Rev 0.1a

Hilliard Ohio 43026 RE-ACM-Owners_Man_R01a.doc

INCORPORATED

INCORPORATEDINCORPORATED

INCORPORATED

SAFETY INSTRUCTIONS

Warning Labels Please

READ ME

SAVE THESE SAFETY INSTRUCTIONS

It should be noted that hazardous voltages are associated with this product. This unit has connections to

AC at lethal amperages and voltages.

Installation should only be done by qualified personnel and in compliance with local regulations and codes.

Special care must be taken in working around the RE-ACM System in order to avoid hazardous voltages

and currents.

Note: In order to reduce the risk of damage to personnel or equipment, please read all instructions in this

manual, particularly warnings noted by the following symbols.

These symbols are used to note procedures that if not closely followed could lead to loss of life or damage

to equipment or property due to electrocution.

Electrocution Hazard Exists

Fire Hazard Exists

A Potential Dangerous Condition

AC -

This symbol denotes AC Voltage is potentially present on this termination.

L1 Phase 1 -

This symbol denotes that this termination is used for the upper phase of a

240 Vrms 3 wire system consisting of Phase 1 (Black wire), Neutral (White wire), and

Phase 2 (Red wire).

N Neutral -

This symbol denotes that this termination is used for the middle wire of a 240

Vrms 3 wire system consisting of Phase 1 (Black wire), Neutral (White wire), and Phase 2

(Red wire).

L2 Phase 2 -

This symbol denotes that this termination is used for the lower phase of a

240 Vrms 3 wire system consisting of Phase 1 (Black wire), Neutral (White wire), and

Phase 2 (Red wire).

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 23 24

Pas de commentaire

Vanner RE Series Manuel d'installation Page 9