Vanner RE Series Manuel d'installation télécharger pdf (Page 56)

RE Installation Manual

4-20



2001 Phone: (614) 771-2718 RE-4500

Vanner Inc. FAX: 614-771-4904 Owners Manual

4282 Reynolds Dr. www.vanner.com Rev 01e

Hilliard Ohio 43026 RE-Installation_Manual_Rev01e 910157-A

INCORPORATED

INCORPORATEDINCORPORATED

INCORPORATED

Choose the "End Chrg Type" to be "<DC

CURRENT." Press the Top Right Key.

Next make the "End Chrg Set'g" "20.0 Adc" (

10 A

for the RE48-4500

) or whatever ending current is

correct for your battery bank. Press the Top Right Key.

And last, set "Charge Timeout" to "24.00 Hours."

Press ESC to go back up the menu.

During this final charging step, the inverter will hold the

battery bank at the voltage setting until the battery current

falls to less than the setting or until a day has gone by. The

inverter will then go back to the FIRST step, and start

over.

Example 2 – 7 Step Charging Cycle

This example is for the factory setting 7 step charging steps.

This 7 step charging cycle is a 7-stage bulk charge for flooded

lead acid batteries (similar to the Vanner Incorporated TruSine

TSC24-4500).

To change or review the setpoints, use the ICC remote to go up

to the charger menu and look at "Charging Stges." The

Charging Stages factory setting is 7 meaning there are 7 stages

or steps the inverter performs when charging the batteries. Hit

the MENU key to bring up the charging steps menu.

Perform the first set of charging steps:

Use the remote to set "Charge Step #" to 1. (The first

charging stage) Press the Top Right Key.

"Charge Stage ," the charging stage name, is "STRT,"

obviously standing for "start". Press the Top Right

Key.

The "Charge Type" is "DC CURRENT," or current

into or out of the battery. Press the Top Right Key.

The "Charge Setting" is "0.0 Adc," meaning nothing

will happen. Press the Top Right Key.

The "Trigger Type" is "<DC VOLTAGE," meaning

the inverter charger will leave the first charging stage

when the battery voltage is less than some number.

Press the Top Right Key.

The "Trigger Settng" is "22.00 Vdc," (

44 V

for the

RE48-4500

) the voltage you want the batteries to

1 2 ... 51 52 53 54 55 56 57 58 59 60 61 ... 91 92

Commentaires sur ces manuels

Pas de commentaire

Vanner RE Series Manuel d'installation Page 56

Commentaires sur ces manuels

Produits connexes et manuels pour Adaptateurs et onduleurs de puissance Vanner RE Series